I deleted all the files from the pc libraries and the sd cards,i paste the new ones ,i uploaded the sketches on controller and display and the only thing shows is v. 5.0 and 1 red dot but finaly doesn't start.........also none message apperars like update is ready to install
I found my mistake......when uploading the sketches must not power up the controller or the display or connect both with the ethernet cable.!!!!!.....only connect the pc with controller arduino via usb cable and do the upload.Do the same with the display and diskonnect the usb.Connect the ethernet cable and power the controller.So a message appear to press the update button....thas all
I found my mistake......when uploading the sketches must not power up the controller or the display or connect both with the ethernet cable.!!!!!.....only connect the pc with controller arduino via usb cable and do the upload.Do the same with the display and diskonnect the usb.Connect the ethernet cable and power the controller.So a message appear to press the update button....thas all