07-26-2018, 10:40 PM
Hello, well I'm happy to say I finally have a nice faceplate for the controller. 
I've been trying to find the best solution and happen to come across a product that used a PCB for the faceplate so that's exactly what I did as it's the cheapest method without a mass order, definitely better than trying to remember or good old masking tap...
I only got a front faceplate made as I wanted to make sure it would work but will be getting side plates soon.
![[Image: DSCN7115-Optimized.JPG]](https://www.robo-tank.ca/pictures/Gen3/DSCN7115-Optimized.JPG)
![[Image: DSCN7108-Optimized.JPG]](https://www.robo-tank.ca/pictures/Gen3/DSCN7108-Optimized.JPG)
I've been trying to find the best solution and happen to come across a product that used a PCB for the faceplate so that's exactly what I did as it's the cheapest method without a mass order, definitely better than trying to remember or good old masking tap...
I only got a front faceplate made as I wanted to make sure it would work but will be getting side plates soon.
