07-03-2018, 01:31 PM
So I just purchased a Robo-Tank yesterday so obviously I haven't received it yet. I have a few questions after looking around in the .pdfs in the downloads section...
In Robo-Tank Gen3 Connecting the Equipment.pdf: When connecting the water temperature sensor, there are 3 wires (pos, ground, data) but plug 6 for the water temperature sensor only shows data and +5v. Where does the ground wire connect? I see plug 14 has 2 spare grounds, would it be connected here? why not have a plug with 3 wires? I have the same question with the auto fish feeder on plug 8 and plugs 15-18 for PWM.
Plugs 1 and 2 appear to be USB connectors for the Power Bars however in the order page when you add on an extra 8 outlet Power Bar, it says it includes a VGA cable. Was the VGA cable just for an older version? The extra power bar shows 6 outlets on top and 2 on the side, but the main one is with all 8 on top - will they be the same?
Sorry for all the questions, I'm just excited to get it going!
In Robo-Tank Gen3 Connecting the Equipment.pdf: When connecting the water temperature sensor, there are 3 wires (pos, ground, data) but plug 6 for the water temperature sensor only shows data and +5v. Where does the ground wire connect? I see plug 14 has 2 spare grounds, would it be connected here? why not have a plug with 3 wires? I have the same question with the auto fish feeder on plug 8 and plugs 15-18 for PWM.
Plugs 1 and 2 appear to be USB connectors for the Power Bars however in the order page when you add on an extra 8 outlet Power Bar, it says it includes a VGA cable. Was the VGA cable just for an older version? The extra power bar shows 6 outlets on top and 2 on the side, but the main one is with all 8 on top - will they be the same?
Sorry for all the questions, I'm just excited to get it going!
