09-28-2018, 04:51 PM
No problem aquaalgae, on a side note I got those solid state relays so I'll be able to make up the PCB soon, hopefully I have those ready to ship in a month or so.
Thanks for the suggestions, now's the best time to get them in everyone.
I will add a delay for the feeder, I can see that useful to let water calm before feeding. I might be a little confused about changing a relay state when feed mode is exited. Currently when the feed mode is over the relays go back to the state they were in before the feed started. Do you have a scenario?
Oops on the typo, I seem to do that. Question is would I have spotted that when adding it again, probably not... If you search the controller sketch for "Fish Where Manually Feed" there's one instance of it, you can change it to anything you want. You'll see the other alerts above and below which you can change if you like.
Thanks for the suggestions, now's the best time to get them in everyone.
I will add a delay for the feeder, I can see that useful to let water calm before feeding. I might be a little confused about changing a relay state when feed mode is exited. Currently when the feed mode is over the relays go back to the state they were in before the feed started. Do you have a scenario?
Oops on the typo, I seem to do that. Question is would I have spotted that when adding it again, probably not... If you search the controller sketch for "Fish Where Manually Feed" there's one instance of it, you can change it to anything you want. You'll see the other alerts above and below which you can change if you like.
