04-13-2018, 01:32 AM
Hi, there's an update available for a few fixes listed below. I also updated the outlets code so the new I2C power bars could be used, there are no visual changes. There was suppose to be new LED modes but I wasn't happy with it as some control was gone so I'm going to redo.
- Fixed ATO, was only working in test mode
- Fixed Air and Light temperature label on alert page, they were swapped
- Fixed Manual button on home page for resume outlets to Auto mode, had to be pressed twice
- Fixed Sensor page, Air temperature overlapped the light temperature section
The new hardware is almost finished so I'll will be working on a software update soon.
- Fixed ATO, was only working in test mode
- Fixed Air and Light temperature label on alert page, they were swapped
- Fixed Manual button on home page for resume outlets to Auto mode, had to be pressed twice
- Fixed Sensor page, Air temperature overlapped the light temperature section
The new hardware is almost finished so I'll will be working on a software update soon.
