Robo-Tank DIY Aquarium Controller Forum › Robo-Tank Arduino Based - NO LONGER AVAILABLE › DIY Hardware Questions v
About stirrer

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
About stirrer
jmcadsl Offline
Registered User
Posts: 37
Threads: 7
Likes Received: 0 in 0 posts
Likes Received: 0 in 0 posts
Reputation: 0
Joined: Feb 2018
Country: Spain
#1
04-02-2018, 01:11 PM (This post was last modified: 04-03-2018, 01:09 AM by Rob F.)
Hi again!!!

I have a question about the use of the stirrer function.
I have 4 dosing pumps with 4 stirrers.
The connection for the pumps its ok, but the question its about stirrer.
In the manual i saw i must use ports 9-10-11-12 of the led outputs, then my question its...
Can i take Ground from the connexion DC Grounds at the left side?
I suppose i will have 5v in every stirrer channel?

Thanks!
Find
Reply to top


Messages In This Thread
About stirrer - by jmcadsl - 04-02-2018, 01:11 PM
RE: About squirrer - by Rob F - 04-02-2018, 05:10 PM
RE: About squirrer - by jmcadsl - 04-03-2018, 12:15 AM
RE: About squirrer - by Rob F - 04-03-2018, 01:06 AM
RE: About stirrer - by jmcadsl - 04-03-2018, 01:20 AM
RE: About stirrer - by Dom59 - 10-30-2019, 12:54 PM
RE: About stirrer - by Rob F - 10-30-2019, 03:05 PM
RE: About stirrer - by Dom59 - 10-31-2019, 11:54 AM
RE: About stirrer - by Rob F - 10-31-2019, 05:54 PM
RE: About stirrer - by Dom59 - 11-01-2019, 02:19 AM
RE: About stirrer - by Rob F - 11-01-2019, 10:03 AM
RE: About stirrer - by Dom59 - 11-01-2019, 11:59 AM

Forum Jump:

Current time: 04-30-2024, 02:31 AM