11-11-2017, 11:12 AM
hmmm, that doesn't make any sense, you can upload a test sketch to the controller Arduino and test on the board.
Another thing to try, open the serial monitor in the Arduino IDE for the controller Due. You should see the following.
Initializing sd card...
SUCCESS - sd card initialized.
SUCCESS - Found index.htm file.
eepromValue: 50
Starting Controller -------------------65
Startup Complete -------------------9416
Startup Complete -------------------9619
Then enable the internet and you should get the following except with valid info beside each line.
Connecting to Network -------------------29431
Alert To Email Address:
Alert From Email Address:
smtp2go Username For Alerts:
smtp2go Password For Alerts:
Connecting to Router
Connected to Router Successfully
Web Access Username:
Web Access Password:
My Local IP address:
My External IP Address:
Connected to Network -------------------36535
Another thing to try, open the serial monitor in the Arduino IDE for the controller Due. You should see the following.
Initializing sd card...
SUCCESS - sd card initialized.
SUCCESS - Found index.htm file.
eepromValue: 50
Starting Controller -------------------65
Startup Complete -------------------9416
Startup Complete -------------------9619
Then enable the internet and you should get the following except with valid info beside each line.
Connecting to Network -------------------29431
Alert To Email Address:
Alert From Email Address:
smtp2go Username For Alerts:
smtp2go Password For Alerts:
Connecting to Router
Connected to Router Successfully
Web Access Username:
Web Access Password:
My Local IP address:
My External IP Address:
Connected to Network -------------------36535