03-07-2017, 04:52 PM
(03-07-2017, 03:13 PM)roland33 Wrote: Hello Rob,
Thanks for the update, that went really fast .....
The feeder run now perfectly, would it be able in future to ad more times for feeding?
The dosing pumps are still quite irregular, like I have discribe to you.
I suspect a problem with the software, because the running time influence each other.
An other question: Is it able to use a sensor as a switch (on/off) and use this status in the rules, so it would be able to create different scenes with the outlets and change it with switches.
Thankyou for your good work!!
Hi Roland, glad the feeder is working again, I will be adding more feeding times, soon I'll be adding more schedules for a lot of things. For feeding I was going to go 4 or 5 times per day.
For the dosing pumps can you try two things, hopefully first does it. Go to "system" "settings" and press "sync" then check to see if its better. If not then do the "restore defaults" that should solve it. I don't think its anything you've done as you have them running.
You can use any type of DC switch as a sensor on any of the 5 sensor ports for this, it would connect the same way as a float switch. Then in the software change the port type to "float switch" and setup the rule.
