05-18-2023, 09:09 PM
Oh no, sorry to see this, we will get there.
Address 63 is for the pH circuit, that's a hex value 0x63 so in reef-pi it's 99 on the pH driver.
Address 68 is for the real time clock, you can ignore that one.
Address 40 and 70 are for the "extra ports" which is that error, in reef-pi the driver for extra ports uses 64 (0x40).
The error on the dashboard is likely related to pH, if you delete pH from pH tab you need to delete the chart on the home page first.
Try 3 commands below in the SSH terminal, this will reset everything. After it goes through the install again for the DC port you should be able to add each port directly to "equipment" tab (if connector is an outlet) or "dosing" tab (if connector is a jack). Any time you make some changes it's a good idea to go to the "configuration" tab and then the "admin" sub-tab and press the "reload" button. When it asks which Robo-Tank controller you have select v3.
wget -c https://www.robo-tank.ca/reef-pi_install_files.zip
unzip reef-pi_install_files.zip
sudo bash reef-pi_install_files/install_reefpi.sh
Address 63 is for the pH circuit, that's a hex value 0x63 so in reef-pi it's 99 on the pH driver.
Address 68 is for the real time clock, you can ignore that one.
Address 40 and 70 are for the "extra ports" which is that error, in reef-pi the driver for extra ports uses 64 (0x40).
The error on the dashboard is likely related to pH, if you delete pH from pH tab you need to delete the chart on the home page first.
Try 3 commands below in the SSH terminal, this will reset everything. After it goes through the install again for the DC port you should be able to add each port directly to "equipment" tab (if connector is an outlet) or "dosing" tab (if connector is a jack). Any time you make some changes it's a good idea to go to the "configuration" tab and then the "admin" sub-tab and press the "reload" button. When it asks which Robo-Tank controller you have select v3.
wget -c https://www.robo-tank.ca/reef-pi_install_files.zip
unzip reef-pi_install_files.zip
sudo bash reef-pi_install_files/install_reefpi.sh