09-04-2016, 07:07 AM
Hi,
I have the display and main controller connected by the UTP cable.
Humidity/temp sensor works and all seems okay.
Connected my scope but... at this moment, I cannot get any signal from the PWM light outputs.
Put al the sliders half way in all modes, no luck.
The Temporary Light Modes is the same.
I must be doing something wrong here... ;-)
Kind regards,
Arne.
I have the display and main controller connected by the UTP cable.
Humidity/temp sensor works and all seems okay.
Connected my scope but... at this moment, I cannot get any signal from the PWM light outputs.
Put al the sliders half way in all modes, no luck.
The Temporary Light Modes is the same.
I must be doing something wrong here... ;-)
Kind regards,
Arne.