06-20-2021, 09:08 AM
Hello:
I recently set up my Robo-Tank/Reef-pi system and put my two return pumps under the control of DC 1 and DC 2 (through an IoT realay). All worked pretty much as expected and the controls showed up under 'Outlets', which are available under 'Equipment', and I was able to create macros and timers to turn them on and off. Very good.
Now, I would like to do the same thing using DC 4 and DC 5, but those outputs don't show up under 'Outlets'. Instead, they are under 'Jacks', but I see no way to turn them on and off as I was able to do for DC 4 and DC 5.
Can someone help me understand the concept here?
Thanks,
Phil
I recently set up my Robo-Tank/Reef-pi system and put my two return pumps under the control of DC 1 and DC 2 (through an IoT realay). All worked pretty much as expected and the controls showed up under 'Outlets', which are available under 'Equipment', and I was able to create macros and timers to turn them on and off. Very good.
Now, I would like to do the same thing using DC 4 and DC 5, but those outputs don't show up under 'Outlets'. Instead, they are under 'Jacks', but I see no way to turn them on and off as I was able to do for DC 4 and DC 5.
Can someone help me understand the concept here?
Thanks,
Phil