01-10-2021, 09:31 AM
Sorry to hear about the troubles, glad you're getting through it though.
To remove that header it helps to cut it up with some cutters so you can pull each pin as you heat them, I hope it doesn't give you too much trouble.
The plate for the outlets isn't mandatory, it's just there for some extra support to the top of case. My first design was without it and it worked but there was a little flex when pushed on so I squeezed in the plate.
If your dosing pumps are 12v DC you can connect directly to a DC port and you'll have speed control in reef-pi. The DC ports can be used as outlets or jacks.
Yeah the pinout for the universal power bar is the same but only using outlet 1-6, here's the list, I just put a note on it for the power bar.
https://docs.google.com/document/d/1uFP4...=h.4i7ojhp
To remove that header it helps to cut it up with some cutters so you can pull each pin as you heat them, I hope it doesn't give you too much trouble.
The plate for the outlets isn't mandatory, it's just there for some extra support to the top of case. My first design was without it and it worked but there was a little flex when pushed on so I squeezed in the plate.
If your dosing pumps are 12v DC you can connect directly to a DC port and you'll have speed control in reef-pi. The DC ports can be used as outlets or jacks.
Yeah the pinout for the universal power bar is the same but only using outlet 1-6, here's the list, I just put a note on it for the power bar.
https://docs.google.com/document/d/1uFP4...=h.4i7ojhp
