|
ATO Sensor Holder
|
Posts: 4
Threads: 0 Likes Received: 0 in 0 posts Likes Received: 0 in 0 posts Reputation: 0 Joined: May 2016 Country: 
06-25-2016, 01:24 AM
Yes I know that the PLA is not well in seawater, it biomaterial and bacteria in salt water it decomposes over time but there are special sprays sprayed ktorym holder before inserting it into the salt water. Back when I was in pushing holder hair I tested my new printer that I've built a lot, I thought about this issue PLA and saltwater.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
ATO Sensor Holder - by ChrisC - 05-14-2016, 09:12 AM
RE: ATO Sensor Holder - by Rob F - 05-14-2016, 06:44 PM
RE: ATO Sensor Holder - by ChrisC - 05-14-2016, 10:54 PM
RE: ATO Sensor Holder - by rott - 05-15-2016, 06:23 PM
RE: ATO Sensor Holder - by miki222 - 06-23-2016, 12:15 PM
RE: ATO Sensor Holder - by Steve S - 06-23-2016, 02:04 PM
RE: ATO Sensor Holder - by Rob F - 06-23-2016, 12:38 PM
RE: ATO Sensor Holder - by ChrisC - 06-23-2016, 01:06 PM
RE: ATO Sensor Holder - by miki222 - 06-23-2016, 02:23 PM
RE: ATO Sensor Holder - by ChrisC - 06-24-2016, 10:47 AM
RE: ATO Sensor Holder - by Dom59 - 06-24-2016, 10:54 AM
RE: ATO Sensor Holder - by ChrisC - 06-24-2016, 03:02 PM
RE: ATO Sensor Holder - by Steve S - 06-24-2016, 03:22 PM
RE: ATO Sensor Holder - by miki222 - 06-25-2016, 01:24 AM
|
| Current time: 04-25-2024, 10:32 AM |
