06-18-2020, 02:06 AM
(This post was last modified: 06-18-2020, 02:08 AM by Rob Wheatley.)
Will check but think I have one for off and one for on on each wavemaker.
Pressing resume sets it to do what it is timed to do.
Do you have a list of the pin assignments for the new pcb you are doing, that way I can set my Pi up to use the correct pin as well.
Pressing resume sets it to do what it is timed to do.
Do you have a list of the pin assignments for the new pcb you are doing, that way I can set my Pi up to use the correct pin as well.