11-21-2019, 04:42 AM
(11-20-2019, 12:32 PM)loksik.lubos Wrote: Hello, it is possible to create an automatic water change in the aquarium over time with multiple settings. I will determine how much water I want to drain and then refill
Hi Loksik, you could setup an automatic water change using the maintenance mode with custom rules using float switches or non-contact sensors to turn the pump on/off. You can schedule when the maintenance mode activates which can start the water change by turning on a pump to drain the water, once the water drains to the low sensor a custom rule can turn it off and another pump could be turned on to fill it back up, once the water hits the high level sensor the fill pump could be turned back off. In the maintenance mode settings you can select which outlets or DC accessory ports get turned on/off during maintenance. When the maintenance mode comes to an end everything will go back to normal operating mode.