LED Signal Converter Jumper Configuration - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank Arduino Based - NO LONGER AVAILABLE (https://www.robo-tank.ca/forum/forum-16.html) +--- Forum: Robo-Tank Circuit Board Questions (https://www.robo-tank.ca/forum/forum-17.html) +--- Thread: LED Signal Converter Jumper Configuration (/thread-65.html)

LED Signal Converter Jumper Configuration - Rob F - 02-17-2016 Here's how the jumpers are set for each of the signal types on the 16 channel LED signal converter board. The number between the jumpers is the channel it changes. RE: LED Signal Converter Jumper Configuration - Dom59 - 02-17-2016 Thanks Rob, it's clear. RE: LED Signal Converter Jumper Configuration - aquaalgae - 06-25-2018 Is this board for sale on your website or is it included in the full kit? I have 12 channels that need 5v PWM and 3 channels that need 10v PWM. RE: LED Signal Converter Jumper Configuration - Rob F - 06-25-2018 I do have that board for sale in the store however it's only 8 channels now as 16 was overkill. If you ordered the full plug and play kit I would throw it in along with a small 3D printed case for it. https://www.robo-tank.ca/en/Break-Out-Boards/8-Channel-5v-PWM-Digital-to-Analog-Signal-Converter-Kit-p138c63.html