+- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum)
+-- Forum: Robo-Tank Arduino Based - NO LONGER AVAILABLE (https://www.robo-tank.ca/forum/forum-16.html)
+--- Forum: DIY Hardware Questions (https://www.robo-tank.ca/forum/forum-18.html)
+--- Thread: Connection between display and power bar board lost (/thread-57.html)
RE: Connection between display and power bar board lost - zfreak_1125 - 05-09-2016
Ran the soldering iron over IC3 and inspected to make sure nothing jumpered by accident.
Set it up to test again and still the same result. Test sketch is hanging at "Serial2 sent signal to power bar"
RE: Connection between display and power bar board lost - Rob F - 05-09-2016
I guess we'll have to swapped what you have. I'll email you.