After installation from 4,2 to 5,13 problem - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank Arduino Based - NO LONGER AVAILABLE (https://www.robo-tank.ca/forum/forum-16.html) +--- Forum: Software Questions (https://www.robo-tank.ca/forum/forum-19.html) +--- Thread: After installation from 4,2 to 5,13 problem (/thread-428.html) Pages:
1
2
|
RE: After installation from 4,2 to 5,13 problem - vilich - 06-17-2019 I made an update to version 5.13, using the library that sent me and now works all the way normally. The temperature for the water and led lights is seen in a normal way. Thanks very much. I can not find the ports for the temperature of the air. I read in the forum about this, but I'm a bit confused how to do it. RE: After installation from 4,2 to 5,13 problem - Rob F - 06-17-2019 No problem glad to hear you got it. For the ports it's only labels that changed, if you look at face plate you see analog 1 - port 1. On yours analog 1 is still analog 1 so if yours is port 7 change it to port 1. If you called ATO main sensor port 2 just call it port 6 now. Everything else is the same. Temps are slightly different because I called them water, air, light, temp 1,2,3,4. Now temp 1 = water, temp 2 = air, temp 3 = light, temp 4 = temp 1, temp 5 = temp 2. https://www.robo-tank.ca/forum/Thread-Controller-Faceplate RE: After installation from 4,2 to 5,13 problem - vilich - 06-18-2019 Hi Rob I understood everything. Now everything is normal. Thanks for your patience. Thanks a lot. All the best. |