Tunze Flow Pumps - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Members Zone (https://www.robo-tank.ca/forum/forum-11.html) +--- Forum: DIY - Do It Yourself (https://www.robo-tank.ca/forum/forum-14.html) +--- Thread: Tunze Flow Pumps (/thread-391.html) |
Tunze Flow Pumps - Gordon Lehmann - 02-28-2019 I do not have the robo tank yet! I hope the main board will be available soon. I would like to understand the connection as I can connect my flow pumps. So the run as a DC accessory my Tunze pumps have a DIN 5 pin plug in the pin 1 and 3 with plus and minus are occupied and the pumps run with 10 volts I step down to 10 volts regulate but how exactly are the connected pumps? RE: Tunze Flow Pumps - Rob F - 02-28-2019 I'll try and set you up as soon as I can, I just have way too much on my plate right now. Sorry I can't answer this question, I would need the pumps to have any chance at figuring it out. Unfortunately at this point you would be on your own with figuring that out. RE: Tunze Flow Pumps - Gordon Lehmann - 03-19-2019 The pump voltage I can correct with stepdown ore with resistance from 12 to 8 volt. The pumps get 24 volt from own power supply And controlled by two cable +/- max 8 volt but how connect to Robo controller ? RE: Tunze Flow Pumps - Rob F - 03-19-2019 Sorry I don't have any answers at this time, hopefully one day I will. |