Dosing Pump with Magnetic Stirrers - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Members Zone (https://www.robo-tank.ca/forum/forum-11.html) +--- Forum: DIY - Do It Yourself (https://www.robo-tank.ca/forum/forum-14.html) +--- Thread: Dosing Pump with Magnetic Stirrers (/thread-380.html) |
Dosing Pump with Magnetic Stirrers - Aquadominus - 12-17-2018 As I said in the title I decide to build a 4ch dosing pump with Magnetic Stirrers for Robotank. The case is from MDF... I drill the holes and I painted black I add also LED indication lights the pumps are connected with utp... then I drill the case for the Magnetic Stirrers buttons I connect Rob's PCB with the motors and the buttons... and I place everything in my case... I stabilize the motors with shelves edges... and ready.... Because the bottom of the bottles that I have found is not straight and the magnets are jumping and making a lot of noise I decide to build my own liquid container from polycarbonate in the dimensions of my case... After that I am going to build a LED light for my Discus Tank... RE: Dosing Pump with Magnetic Stirrers - Rob F - 12-17-2018 Hi Aquadominus, that looks really good, now you just need the controller. Isn't it amazing how hard it is to find a decent bottle with a flat bottom, mine are noisy too because the middle has a peak, I actually put my bottles off centered which help. Good luck with your light, I'm sure it will turn out nice. RE: Dosing Pump with Magnetic Stirrers - Aquadominus - 12-18-2018 Thanks Rob the truth is that you helpe me a lot with the stirrers!!!! When I will finish the light I am going to procced with the controller... RE: Dosing Pump with Magnetic Stirrers - Rob F - 12-18-2018 Ah no problem, its nice to see it all together, feel free to post pictures of your light as well. RE: Dosing Pump with Magnetic Stirrers - Aquadominus - 12-18-2018 Absolutely!!!! Now I am in the stage to connect all the heatsinks to create a big one 140cm x 20cm and then to make M3 holes for all the LEDS |