inclined LCD support - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank Arduino Based - NO LONGER AVAILABLE (https://www.robo-tank.ca/forum/forum-16.html) +--- Forum: DIY Hardware Questions (https://www.robo-tank.ca/forum/forum-18.html) +--- Thread: inclined LCD support (/thread-248.html) |
inclined LCD support - simonv92 - 11-04-2017 Hi to all!, has anyone designed an inclined lcd support to put the lcd on a table? Any idea will be appreciated :D Thank you very much! Simone RE: inclined LCD support - Rob F - 11-05-2017 Hi Simone, I did create one a while ago but haven't actually printed it yet. I have the base at a 20, 30 or 40 degree angle. RE: inclined LCD support - simonv92 - 11-05-2017 Hi Rob, if you can send me the file I’ll try to print it... which Cad have you used to design it? RE: inclined LCD support - Rob F - 11-05-2017 I'll email the file to you, I use SketchUp. RE: inclined LCD support - simonv92 - 11-05-2017 Thank you very much Rob! |