+- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum)
+-- Forum: Robo-Tank Arduino Based - NO LONGER AVAILABLE (https://www.robo-tank.ca/forum/forum-16.html)
+--- Forum: DIY Hardware Questions (https://www.robo-tank.ca/forum/forum-18.html)
+--- Thread: LED DRIVER 10PWM AND 10 ANALOG (/thread-237.html)
LED DRIVER 10PWM AND 10 ANALOG - apanelmarcin - 06-18-2017
HI EVERY ONE.
I GOT PROBLEM WITH MY DRIVERS MEANWELL LCM60.
When a Meanwell LCM-60 0-10v PWM driver is connected to the converter output it doesn't dim to 0%, the LED's glow at about 5% when sliders its on minimum. When the converter jumper is set to only put out 0-5v the driver does dim to 0% but doesn't get full power obviously.
Using a voltmeter with no driver connected the low voltage is .03 if the converter is set to put out 5v or 10v. However, if the driver is connected the low voltage jumps to .5v when the converter is set to 10v output which explains why the LED's still get power.
can some one get any solutions for that .
RE: LED DRIVER 10PWM AND 10 ANALOG - Rob F - 06-18-2017
Hi Marcin, as you know I'm looking into it, hopefully someone can jump in with some ideas.
RE: LED DRIVER 10PWM AND 10 ANALOG - apanelmarcin - 06-18-2017
(06-18-2017, 03:13 PM)Rob F Wrote: Hi Marcin, as you know I'm looking into it, hopefully someone can jump in with some ideas.
THANKS ROB.
HOPEFULLY SOMETHING CAN BE DONE WITH THAT DRIVERS
RE: LED DRIVER 10PWM AND 10 ANALOG - apanelmarcin - 07-16-2017
Sorted out. Just added resistor 1K between ground and signal to driver on every each channel.
RE: LED DRIVER 10PWM AND 10 ANALOG - Rob F - 07-16-2017
Glad to hear to that worked and you figured out the correct resistor.
