PH Sensor board - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank (https://www.robo-tank.ca/forum/forum-1.html) +--- Forum: DIY Hardware Questions (https://www.robo-tank.ca/forum/forum-3.html) +--- Thread: PH Sensor board (/thread-1774.html) |
PH Sensor board - brett021 - 12-29-2022 Is that a female usb connector on the Robo-Tank Isolated pH Circuit for reef-pi? If so can anyone provide the pinout. I am trying to figure out what cable I need to hook it to my RPi. Thanks, Brett RE: PH Sensor board - Rob F - 12-29-2022 Hi Brett, the pH board has standard header pins to connect it, it requires +5v, GND, SDA and SCL. I do send along a set of 10" header wires so you can connect it directly to the Pi GPIO header pins. If you have something else you want to connect it to I have some header pins with pins so they can be soldered or whatever. RE: PH Sensor board - brett021 - 12-29-2022 Thanks. I'm designing a board to run reef pi on a quarantine tank. RE: PH Sensor board - Rob F - 12-29-2022 Right on, sounds like fun. :) RE: PH Sensor board - brett021 - 01-01-2023 (12-29-2022, 11:24 PM)Rob F Wrote: Right on, sounds like fun. :)Rob, Do you use the JST-XH series connectors? I wanted to order some of the sensors from you and I wanted to be sure they are plug and play for my QT board I'm building. I plan on buying your Robo tank controller for my main reef tank when I get it set up. Thanks, Brett RE: PH Sensor board - Rob F - 01-01-2023 Hi Brett, happy new year! Yeah the 4 pin are XH with 2.5mm spacing, the 3 pins are PH with 2.0mm spacing. RE: PH Sensor board - brett021 - 01-01-2023 (01-01-2023, 07:56 PM)Rob F Wrote: Hi Brett, happy new year! Yeah the 4 pin are XH with 2.5mm spacing, the 3 pins are PH with 2.0mm spacing.Thanks for the info and Happy New year to you also. |