Sensor module - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank (https://www.robo-tank.ca/forum/forum-1.html) +--- Forum: Current News and Design Ideas (https://www.robo-tank.ca/forum/forum-8.html) +--- Thread: Sensor module (/thread-1754.html) |
Sensor module - adammac1 - 10-09-2022 My " new" sensor module board has a 3 pin connector above the optical port, what are those for? I can't get my ato running and I'm wondering if those have anything to do with it. Also, does a non contact sensor need a pull-up resistor, pull down resistor or none? RE: Sensor module - Rob F - 10-09-2022 Hi, that extra 3 pin connector is for the new optical sensors. The one I've been using for years seems to have been discontinued and the replacement has the 3 pin connector and a different resistor requirement. When you set the jumpers that set the port active to "optical" it will enable the 3 pin optical connector and the original 4 pin optical. The non-contact does use a pull-down resistor but that's built in so nothing required. |