Had a problem with outlet 6 & 7... - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank Arduino Based - NO LONGER AVAILABLE (https://www.robo-tank.ca/forum/forum-16.html) +--- Forum: Robo-Tank Circuit Board Questions (https://www.robo-tank.ca/forum/forum-17.html) +--- Thread: Had a problem with outlet 6 & 7... (/thread-167.html) |
Had a problem with outlet 6 & 7... - Arne - 09-16-2016 Hi, I had a problem with outlet 6 and 7. This caused the problem... [attachment=157] [attachment=158] Was this tested?? Kind regards, Arne. RE: Had a problem with outlet 6 & 7... - niksunen - 09-16-2016 If you had soldering iron, you can easily remove that "bridge" between those points. :) RE: Had a problem with outlet 6 & 7... - Rob F - 09-16-2016 Hi Arne, oh no that doesn't look good, because you didn't have me program and mount the Arduinos I didn't test them as I don't open them. I use my Arduinos for testing in this case. I don't think it will have damaged the board, if you can break the solder with your soldering iron it should be ok. RE: Had a problem with outlet 6 & 7... - Arne - 09-16-2016 Thanks, I already did solve it by removing this shortage... ;-) But Rob... you did program and mount my Arduinos... RE: Had a problem with outlet 6 & 7... - Rob F - 09-16-2016 Oh, my bad, I looked back on your order and saw you didn't check the option so I assumed I didn't, that's why I mentioned that before. Makes sense I wouldn't have seen it anyways, when I check the outlets I simply turn them all on and check for voltage so the short wouldn't have been seen. You can bet I'll be looking at all the boards from now on, I already looked at the ones I have. :) Thankfully they're all good. I've had good luck with these boards, they seem to be pretty well made but yeah sometimes the soldering can be a little sloppy. RE: Had a problem with outlet 6 & 7... - Arne - 09-16-2016 When you switch them all on and off, it's working fine. The problem showed up when I only wanted to control Outlet 6 or 7... I couldn't switch on Outlet 6 unless Outlet 7 was already on. I couldn't switch on Outlet 7 unless Outlet 6 was already on. I know, when you read this it doesn't make sense... ;-) RE: Had a problem with outlet 6 & 7... - Rob F - 09-16-2016 I think it makes sense, that's why I didn't see it if that makes sense. :) RE: Had a problem with outlet 6 & 7... - Arne - 09-16-2016 Yes, it makes sence... ;-)) |