software - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank (https://www.robo-tank.ca/forum/forum-1.html) +--- Forum: Robo-Tank Software Questions (https://www.robo-tank.ca/forum/forum-23.html) +--- Thread: software (/thread-1561.html) |
software - rott - 03-02-2022 Ok so this is the first time I have installed this software So my understanding is the software is it will only show what is connected to it only. I have a fresh install and only have the 9 blue icons on the bottom row of the screen. i have tried to hook up a few different ph probes to it but nothing happens or shows up after reboot of the pi and I am not sure what the connector page is or not I dont seem to have that So what am I doing wrong? RE: software - Rob F - 03-02-2022 If you installed 6.3 you likely won't get a pH probe or temp sensors, need 6.0 or wait a little bit for 6.4. To enable other things you need to go to "settings", then "configure ports". Now click on a port and enable it and set the function to what it will be used for. Then on the home page things will start to appear. RE: software - rott - 03-02-2022 ok so i should of waited LOL RE: software - Rob F - 03-02-2022 Yeah that's probably best, just a little longer. :) RE: software - rott - 03-02-2022 I still need to find the green part that the wires hook to for the rest of the sensors RE: software - Rob F - 03-02-2022 I'm guessing it's in one of those part bins. :) |