DS18B20 probe-negative temperature - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank (https://www.robo-tank.ca/forum/forum-1.html) +--- Forum: Reef-pi Software Questions (https://www.robo-tank.ca/forum/forum-5.html) +--- Thread: DS18B20 probe-negative temperature (/thread-1188.html) |
DS18B20 probe-negative temperature - bucler - 01-24-2021 Hello, First of all everything is working great and I am slowly building up my setup. I decided to move one temperature probe outside the house - everything is working fine, probe is isolated from water, but system is unable to measure negative temperatures. When it drops below 0 reading in reef-pi as always "-1" and when I am checking it directly in console it is something like +41893. I thing i have only installed "sensors" to raspberry to check for temperature and i did not modify anything else. RE: DS18B20 probe-negative temperature - bucler - 01-24-2021 Ok, the reading is w1_slave_temp-virtual-0 Adapter: Virtual device temp1: +4095.9°C RE: DS18B20 probe-negative temperature - Rob F - 01-24-2021 Hi, sorry for the long delay, the forum didn't notify me. I just tried and it shows a negative value so I'm not really sure why it doesn't go lower. Did you check the graph on the temp tab? That's where I checked, didn't happen to look on the dashboard. Do you have another sensor you can try? RE: DS18B20 probe-negative temperature - bucler - 01-25-2021 Ok, apparently it was some problem with raspbian - apt full-upgade fixed it. RE: DS18B20 probe-negative temperature - Rob F - 01-25-2021 There you go, would have never guess that. Thanks for letting us know. |