slow website response

L

loksik.lubos

Member
Question: When I have the web running and I run a simple macro, the controller takes a long time to start the port. Of course, when I use the sensor to start the port, it responds well, but it switches to the web page after 5-7 seconds. I use a Raspberry pi4 with a fast SD card reader. It didn't do this before and when I try to set something up, it takes a long time, which is strange and there is no setting anywhere, there is no delay, max 1 second.
 
Sort by date Sort by votes
loksik.lubos said:
Question: When I have the web running and I run a simple macro, the controller takes a long time to start the port. Of course, when I use the sensor to start the port, it responds well, but it switches to the web page after 5-7 seconds. I use a Raspberry pi4 with a fast SD card reader. It didn't do this before and when I try to set something up, it takes a long time, which is strange and there is no setting anywhere, there is no delay, max 1 second.
Click to expand...
Is the sensor running the same macro? If so and this only happens when reef-pi is loaded in the browser it could be a network connection issue.
 
Upvote 0 Downvote
loksik.lubos said:
The internet connection is very good. When I had the older V1, it was very fast. My internet is 500/100 Mbbs
Click to expand...
Something must have changed, I think it's how the macro is configured. It definitely isn't related to hardware as the software is what does the switching. It won't be related to internet speed as you view this on your local network, it could be a bad network connection but I think its probably related to the macro itself.
 
Upvote 0 Downvote
Back
Top