I previously had rules setup that below a certain PH, it would shut off my AC outlet that controlled my CO2 solenoid. Then I had a schedule that would turn it back on a few hours later. Recently, it shuts it off as the rule states. But once it turns back on, the rule does not run again and the solenoid outlet never shuts off, no matter if the PH gets lower than the set amount or not. Any ideas?
Rules not resetting
- Thread starter RWilt81
- Start date
Hi @RWilt81 did this start happening after you updated or just randomly? I ask because in v6.7 the rule doesn't run again unless it's been reset, as you don't have a rule turning it on maybe that's the cause but if it just randomly stopped working I'm a little stumped off hand. As a test, when the rule turns off the outlet can you reboot the controller and see if it turns back off after the schedule turns it on.
OK so after a reset, the co2 turned back on, it has cycled twice with two rules (one for on and one for off). So the rules seem to be working, only question is, is there a way to program the rules not to run between certain hours? For example, I shut the CO2 off during the night when the lights are off. With the rules, it keeps trying to run at night now
Sorry for my absence. There is no way to disable the rule during a set time, I'll have to look into adding that.