Search results

Thanks Rob, no worries, I can wait for the update.

Yes, I can enable the red dot, then go into the outlet configuration page and setup one of the other outlets and when I come back to the main dashboard the red dot will be gone and sometimes the outlet will be off. On a related note I just tested simulating a power outage and the outlets...

So I'm using temp control, equipment timers, PH monitoring, email alerts and now I'm trying to add some diy 12v dosers. I'll give it a shot.

Hello, I've setup a 12v doser on a DC jack which seems to work fine when I setup a schedule but when I go into calibrate and click "run" nothing happens. I've tried this with the doser enabled and disabled. I've rebooted reef pi which didn't help. Running version 5.2. Am I missing something...

Hey Rob, the issue continued after I swapped to the separate on/off timers. If I remember correctly I changed the existing timers to on/stay on then added new off/stay off timers.  Since then, I deleted all the timers and just added a single new test timer (separate on/off timers) and it seems...

Hey Rob, so the pump is still looping with the separate on and off timers. My Timer settings are: Status: Enabled Function: Equipment Equipment: ATO pump Action: Turn on And then: stay on Month: * Day of the week: * Day of the month:* Hour: 18 Minute: * Second: 0 To turn off the settings are...

Hello,  I setup a 12v pump on DC1 of the equipment extension for an ATO using timers instead of sensors. I set the timers as "on then off" after 10 seconds. I had 4 timers setup. One each at 1 pm 3 pm 5 pm and 7pm. It seemed to work until I came home after a dog walk at 7:30pm and noticed my...

Thanks Rob, as I was installing the Robo tank app it clicked in my mind that it probably can't be loaded with Reef Pi already on the card. I just started over and will start with Reef Pi for now. I managed to setup email alerts so I'm pretty happy with myself. I'll try the Team viewer. That...

I can access reef pi now. Thanks Rob. Is there a certain order of progression to follow now? I'm guessing I install the Robo tank app and start setting equipment up. I'd like to setup remote access so I can view parameters while on vacation. Would that be done after the robo tank app is...

Just got it. The raspbian installer auto filled the username so it wasn't pi anymore it was ewanc. It autodetected my network SSID as well. Maybe a new feature? anyways I think reef pi is installed now. Just going to restart and login

Hi, trying to setup my Pi via SSH but it doesn't recognize the password I setup when installing the OS. I logged into my router to get the IP address for the Pi so I assume that's correct. Trying to login to port 22.  Tried "pi" and "Pi" as the login. I tried the default password. Tried running...