Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
power bar wiring question
#3
(01-16-2018, 02:28 AM)Rob F Wrote: Hi Warren, I think you have it correct, power and GND into regulator and then power and GND out of regulator into relay board. They likely stay on all the time because there's 8.7v coming out of regulator. You'll see a small screw on the regulator, you can adjust the voltage with that to 5v and it should be ok.

Yes, that did it.  I didn't see the little SMT trimmer on that board.  Adjusting it down to 5v made it work as expected.  Thanks! 
Warren
Reply to top


Messages In This Thread
power bar wiring question - by lumpylipton - 01-15-2018, 08:03 PM
RE: power bar wiring question - by Rob F - 01-16-2018, 02:28 AM
RE: power bar wiring question - by lumpylipton - 01-16-2018, 09:23 AM
RE: power bar wiring question - by Rob F - 01-16-2018, 12:22 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Optical water level sensor wiring notorious.jatt 5 2,827 04-06-2018, 01:53 PM
Last Post: Rob F
  Power connection display boards Arne 1 2,065 09-13-2016, 03:39 PM
Last Post: Rob F

Forum Jump:

Current time: 02-24-2021, 07:29 PM