Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
pH Circuit
#1
Hi Rob,

Can I use the atlas-scientific pH Circuit with the reef-pi deluxe aquarium controller?

All the best.
Reply to top
#2
Hi Iliyan, yeah the Atlas circuit will work. It won't solder to the controller board but can sit in the same location and connect using short jumpers.
Reply to top
#3
I guess using the tentacle board is out
Reply to top
#4
The tentacle board will be ok. Just run jumpers from it to the controller just like an Arduino or whatever. However at this time only the pH circuit will be read, you can leave other circuits in the shield but they won't blink at this time.
Reply to top
#5
can I use more than one temp probe?
Reply to top
#6
Yeah you can attached many, Reef-pi's been tested with up to 7 and more should be ok. There's all on one pin so cable length is more a limiting factor but should be plenty. No DHT22 only DS18B20.
Reply to top


Possibly Related Threads…
Thread Author Replies Views Last Post
  Atlas Scientific Multi Circuit I2C Carrier Board ChrisC 31 34,094 09-08-2016, 12:36 AM
Last Post: fietsenrex

Forum Jump:

Current time: 03-29-2024, 06:20 AM