Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tunze Flow Pumps
#1
I do not have the robo tank yet! I hope the main board will be available soon. I would like to understand the connection as I can connect my flow pumps. So the run as a DC accessory my Tunze pumps have a DIN 5 pin plug in the pin 1 and 3 with plus and minus are occupied and the pumps run with 10 volts I step down to 10 volts regulate but how exactly are the connected pumps?


Attached Files Thumbnail(s)
   
206 gallon tank, 42 gallon technic sump, system triton core 7, 8 dosing Pumps, AM Aquarius, AM Reef LED, AM Ocean LED at TC420, AM Temp controller, Skimmer Bubble Magus Curve M7, 3 Tunze flow pumps at Tunze Multi Controller 7096, AM refill system pro
Reply to top
#2
I'll try and set you up as soon as I can, I just have way too much on my plate right now. Sorry I can't answer this question, I would need the pumps to have any chance at figuring it out. Unfortunately at this point you would be on your own with figuring that out.
Reply to top
#3
The pump voltage I can correct with stepdown ore with resistance from 12 to 8 volt.
The pumps get 24 volt from own power supply
And controlled by two cable +/- max 8 volt but how connect to Robo controller ?
206 gallon tank, 42 gallon technic sump, system triton core 7, 8 dosing Pumps, AM Aquarius, AM Reef LED, AM Ocean LED at TC420, AM Temp controller, Skimmer Bubble Magus Curve M7, 3 Tunze flow pumps at Tunze Multi Controller 7096, AM refill system pro
Reply to top
#4
Sorry I don't have any answers at this time, hopefully one day I will.
Reply to top


Forum Jump:

Current time: 05-26-2019, 07:55 AM