(03-07-2017, 04:07 PM)roland33 Wrote: helllo Niksunen
I just work on my controller to finish them. therefore I test the dosingpumps with the same parameter:
one dosingpump run allways without any stop,
one run only with verry verry little steps, you can say they don't run
two run a short time
the other four run normal..
If your dosing pumps work in Software V3.30 it must be a hardwareproblem by me!
Yeah they work fine. I use 4 pumps (1-4) and last morning i was a wake when dosing start, and they run like it should. I have that dosing pump/s don't stop at some point ( i don't remember which version) but now theyre working fine. So i cannot say how those pumps number 5,6,7 and 8 work. But i am adding couple more to my system, because four don't enough :D And i have fresh water tank, lol :D But i need pumps for magnesium and kalium. :D
I don't find much bugs this version yet (or there is not many :D ) one though is sensors page, some values like humidity is little off, but nothing serious :D And i don't know if actual readings are right, but N/A text is off :D
And i don't know if you are planning to add those "signs" / text after that co2 values, (mg/l) so this i cannot call bug :D But i personally like it there, so i added it myself . It helps remind which value you using, ppm, or mg/l :D Some might say there is no need of this, but, i like it.