After installation from 4,2 to 5,13 problem

[vilich]

I made an update to version 5.13, using the library that sent me and now works all the way normally. The temperature for the water and led lights is seen in a normal way.
Thanks very much.
I can not find the ports for the temperature of the air. I read in the forum about this, but I'm a bit confused how to do it.

[Rob F]

No problem glad to hear you got it.

For the ports it's only labels that changed, if you look at face plate you see analog 1 - port 1. On yours analog 1 is still analog 1 so if yours is port 7 change it to port 1. If you called ATO main sensor port 2 just call it port 6 now. Everything else is the same.

Temps are slightly different because I called them water, air, light, temp 1,2,3,4. Now temp 1 = water, temp 2 = air, temp 3 = light, temp 4 = temp 1, temp 5 = temp 2. 

https://www.robo-tank.ca/forum/Thread-Co...-Faceplate

[vilich]

Hi Rob
I understood everything. Now everything is normal.
Thanks for your patience. Thanks a lot. All the best.