Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
After installation from 4,2 to 5,13 problem
#21
I made an update to version 5.13, using the library that sent me and now works all the way normally. The temperature for the water and led lights is seen in a normal way.
Thanks very much.
I can not find the ports for the temperature of the air. I read in the forum about this, but I'm a bit confused how to do it.
Reply to top
#22
No problem glad to hear you got it.

For the ports it's only labels that changed, if you look at face plate you see analog 1 - port 1. On yours analog 1 is still analog 1 so if yours is port 7 change it to port 1. If you called ATO main sensor port 2 just call it port 6 now. Everything else is the same.

Temps are slightly different because I called them water, air, light, temp 1,2,3,4. Now temp 1 = water, temp 2 = air, temp 3 = light, temp 4 = temp 1, temp 5 = temp 2. 

https://www.robo-tank.ca/forum/Thread-Co...-Faceplate
Reply to top
#23
Hi Rob
I understood everything. Now everything is normal.
Thanks for your patience. Thanks a lot. All the best.
Reply to top


Possibly Related Threads…
Thread Author Replies Views Last Post
  Origninal Robo-Tank problem Rob Wheatley 5 1,767 05-31-2020, 05:22 PM
Last Post: Rob F
  Heaters did not shut off after maintenance midwestE 6 2,950 03-09-2019, 07:13 AM
Last Post: midwestE
  Forum Profile Problem Gordon Lehmann 3 2,221 03-06-2019, 02:55 PM
Last Post: Rob F
  Display Problem simonv92 12 4,805 03-04-2019, 09:54 AM
Last Post: Rob F

Forum Jump:

Current time: 05-23-2022, 11:18 AM