Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
12v Relais board
#1
I have two 8-fold relay boards which are operated with 12 volt. Can I connect they normaly to robo tank to operate my 8 fold 240 volt sockets?
206 gallon tank, 42 gallon technic sump, system triton core 7, 8 dosing Pumps, AM Aquarius, AM Reef LED, AM Ocean LED at TC420, AM Temp controller, Skimmer Bubble Magus Curve M7, 3 Tunze flow pumps at Tunze Multi Controller 7096, AM refill system pro
Reply to top
#2
Yes I think the 12v relay will switch with a 5v signal. Just need to power up with 12v.
Reply to top
#3
only to which pins on the robo tank are the 8 relays connected? of the LED channels, I already need 14, ie there are only 2 over
206 gallon tank, 42 gallon technic sump, system triton core 7, 8 dosing Pumps, AM Aquarius, AM Reef LED, AM Ocean LED at TC420, AM Temp controller, Skimmer Bubble Magus Curve M7, 3 Tunze flow pumps at Tunze Multi Controller 7096, AM refill system pro
Reply to top
#4
The controller PCB has some pins on it for the 16 relays, it's separate from the LED channels.
Reply to top
#5
that sounds perfect! So the relay connection is quite normal as on an arduino directly
206 gallon tank, 42 gallon technic sump, system triton core 7, 8 dosing Pumps, AM Aquarius, AM Reef LED, AM Ocean LED at TC420, AM Temp controller, Skimmer Bubble Magus Curve M7, 3 Tunze flow pumps at Tunze Multi Controller 7096, AM refill system pro
Reply to top
#6
yeah exactly like an Arduino directly.
Reply to top


Forum Jump:

Current time: 06-24-2019, 02:20 PM